|
Crop / object of treatment
|
Harmful plants
|
Preparation consumption rate, l/ha
|
Mix consumption rate, l/ha
|
Method, time and conditions of application. Application time for manual (machinery assisted) operations
|
Wait time (application frequency)
|
|
Sugar beet, soybean, spring and winter rapeseed, sunflower, common flax
|
Annual grass weeds (barnyard grass, field sorgho, foxtail species)
|
0.75-1
|
200-300
|
Planting spraying at 2-4 weed leaves stage regardless of crop growth phase
-(3)
|
60(1)
|
|
Perennial grass weeds (quack grass)
|
1-1.5
|
Planting spraying with weeds as high as 10-15 cm regardless of crop growth phase
-(3)
|
The best result and quickest herbicide action of the preparation are achieved by:
- treatment at earlier stages of grass weed growth (starting from 2 leaves);
- optimal selection of application periods (when the bulk of annual grass weeds emerge);
- treatment under weather conditions favorable for plant growth and development.
Application technique. Mix preparation method
Prepare the mix immediately before use. Fill the sprayer tank with water to 3/4 of its volume, slowly add the entire preparation dose while stirring, and rinse preparation remainders several times with water. Pour water after rinsing the preparation vessel to the sprayer tank and top up with water until full while continuously stirring. Prepare the mix and fill the sprayer on dedicated sites that are disinfected afterwards.
Use ground-based beam sprayers Amazone, OPSh-15-01, OPSh-3-24, ON-400, OP-2000-2-01, or similar.
Compatibility
May be mixed with other herbicides intended to control broad-leaved weeds (Betaren Express AM, Betaren 22, Lornet, etc.), as well as with organophosphorous and pyrethroid insecticides. In each specific case, the components to be commingled should be checked for physical and chemical compatibility.
Potential for resistance
No cases of weed resistance to the preparation are recorded.
Phytotoxicity
Do not use the herbicide to treat crops weakened by frost, wind, and insect pests, as well as inadequate nutrition and previously applied herbicides.
Recommendations on protection of valuable flora and fauna objects
The preparation is virtually of no hazard to bees and fish – Hazard Class 3.
Basic provisions of the ‘Guidelines for preventing bee poisoning with pesticides’ and following environmental regulations:
treat plants at wind speed up to 4 or 5 m/sec;
protection boundary zone for bees – min. 2-3 km;
bee’s flight time limitation – 3-4 hours.
Warn apiary owners 4 or 5 days before treatment.
Do not use the preparation in private farms, by aerial method and within the sanitary zone of fishery water bodies 500 m away from the flood line in case of maximum floodwater level, but not closer than 2 km to the existing banks.